EMI/RFI shielding enclosures and housings for PCB's

Series

Please specify the length in mm.
Please specify the width in mm.
Please specify the height in mm.
Allowed maximum size is 64 MiB. You can upload multiple files

1900 series Mu-copper housings/enclosures consist of two parts cover and housing. The Mu-copper housings/enclosures provide excellent RFI/EMI shielding and protection. The EMI-shielded housing is designed to be installed in e.g. an existing plastic housing in order to protect the components against electromagnetic interference. The EMI-shielded housing can also be used to protect an entire printed circuit board in an enclosure against interference from other components in the enclosure.

Having a two-part body allows connectors, displays and switches fitted on the PCB to protrude through the cover and the housing sections. This would not be possible with single-part case bodies. Cutouts in the cover or housing sections or recesses create space for connectors, displays, and switches on the PCB.

PCB’s can be mounted on plastic studs in order to insulate them from the EMI-shielded housing. The studs can be supplied threaded or with extremely strong adhesive, in any shape or size. For heavy-duty applications the cover can be soldered to the housing or attached with studs and screws.

Available in standard dimensions and in any desired shape and size, according to your drawing. You can also specify where the insulating studs should be placed. Available in Mu-copper or in a tinned Mu-copper version for easy soldering.

Advantages
  • Lightweight solution
  • Available in any dimension
  • Shielding close to the source
  • Mounting afterwards is possible
  • No gaskets required
  • Extra shielding layer in combination with other barrier
Typical applications
  • Hand-held test and measurement devices
  • Radio control equipment
  • Wall-mounted monitoring systems
  • Security devices
  • Building control equipment
Options (on request)
  • With insulation layer in the housing part
  • Vents in the cover part for heat dissipation or cooling
  • For additional reduction of radiation, it is possible to add EM absorbers to the EMI housing
Standard EMI-shielding housings/enclosures
EMI shielding housings enclosures technical drawing

Please note:
Tinned steel 0.20 mm and mu-copper 0.30 mm has the best finish

Custom sizes and shapes can be produced on request and according by drawing. Please send your drawing with your request.

When ordering the housing we would like to point out that you have to order the outer bottom housing in terms of dimensions. As an example, in comparison with your chosen material thickness, we have put an example in a table below. For example, when you order 0.12 mm material thickness can with dimensions of 100-200-50 mm, the inside dimensions will be 99.76-119.76-49.88 mm. Standard tolerance for these products is +/- 0.1-0.2 mm.

Material thickness A
Outer 
Inner 		 B
Outer 
Inner		 C
Outer
Inner		 D
cover outer		 E
cover outer		 F
cover outer		    
0.12 mm 200 mm 199.76 mm  100 mm 99.76 mm 50 mm 49.88 mm  200.24 mm 100.24 mm 50.24 mm    
0.18 mm  200 mm 199.64 mm   100 mm  99.64 mm   50 mm  49.82 mm  200.36 mm  100.36 mm  50.36 mm     
0.20 mm 200 mm 199.60 mm  100 mm 99.60 mm  50 mm 49.80 mm  200.40 mm  100.40 mm  50.40 mm    
More results